Table of Contents
How To Install M1 Keyless Entry Door Locks?
In this post-sale guide, we’ll walk you through the step-by-step installation process for M1 smart door locks, ensuring a seamless integration with your home security system.
Applies to: M1 Smonet smart door locks
Installation video:
1. Verify Your Door Dimensions
Before installing a smart lock, make sure your door fits the bill:
Step 1. Cross bore diameter: 54 mm (2.13 inches)
Step 2. Backset:60 /70 mm (2.36 / 2.76 inches)
Step 3. Door thickness: 38 to 48 mm (1.5 / 1.89 inches )
Step 4. Edge bore diameter: 24 mm (0.94 inch)
2. Install Keyless Entry Door Lock
Step 1. Install the deadbolt
For 60mm backset doors, you can install the deadbolt without any adjustments.
If it’s 70mm, the deadbolt length needs to be extended first. To do this, rotate the deadbolt cover upwards and pull it to extend the length. Then, rotate the cover downwards to lock the deadbolt in place.
- Insert the retracted deadbolt with the word “UP” and up arrow facing upwards.
Note: The arrow on deadbolt must stay up, arrow down is going to fail the installation.
- Screw the deadbolt with a screwdriver (not provided).
Parts Required: Deadbolt, Deadbolt Screws, Philips Screwdriver (not provided).
Step 2. Install the Strike Plate
Put the strike pad into the door frame first, and then screw the strike plate in place.
Parts Required: Strike Plate, Strike Pad, Strike Screws, Screwdriver
Step 3. Install the Exterior Assembly
- Place the spindle horizontally before inserting it.
- Turn the spindle several times to test whether the deadbolt extends or retracts smoothly.
- Keep the spindle horizontal and pass the cable under the deadbolt.
Note: Keep the deadbolt retracted (in unlocked status) and do not insert any keys during installation.
Parts Required: Exterior Assembly
Step 4. Install the Mounting Plate
- Pass the spindle through the central hole and the cable through the right bottom hole.
- Screw the mounting plate firmly while ensuring proper alignment.
Note: Please keep the exterior assembly straight when installing the mounting plate.
Parts Required: Mounting Plate, Mounting Plate Screws, Screwdriver ( not provided)
Step 5. Install the Interior Assembly
- Plug the cable into the port on the circuit board. Make sure the connector is securely matched with the pins.
- Face the door from the outside.
If the hinge is on the left, the door is left-handed. Please push the direction button on the circuit board to “L”, turn the door knob to be horizontal.
If the hinge is on the right, the door is right-handed. Please push the direction button on the circuit board to “R”, turn the door knob to be vertical.
- Face the door from the outside.
If the hinge is on the left, the door is left-handed. Please push the direction button on the circuit board to “L”, turn the door knob to be horizontal.
If the hinge is on the right, the door is right-handed. Please push the direction button on the circuit board to “R”, turn the door knob to be vertical.
- Screw the interior assembly.
Parts Required: Interior Assembly, Interior Assembly Screws, Screwdriver (not provided)
Step 6. Insert the Batteries
Note: Use new, non-rechargeable alkaline batteries only.
After completing the six steps above, your smart door lock is all set up. If you need a visual guide, check out our handy installation video. Enjoy the convenience and security of your new smart lock!